page 7
reverse
switch
10. Light Kit Assembly.
Install 1 medium base 6.5 watt LED bulb
(included).
Important
: When replacing bulb, please
allow bulb and glass shade to cool down
before touching.
Partially loosen the 3 thumbscrews in
the light kit plate. Raise glass shade and
hold it in place in the base of the light kit
plate. Secure glass shade by tightening
the thumbscrews until they touch the
rubber ring on the glass shade.
Do NOT
overtighten thumbscrews as glass may
crack or break.
CAUTION
: Leave rubber ring on glass
shade intact as this (along with the
thumbscrews) will help hold the glass
shade in place.
switch housing
glass shade
bulb
thumbscrew
light kit plate
11. Testing Your Fan.
thumbscrew
fan
pull chain
extension
light
pull chain
extension
motor housing
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall
switch (if applicable). Test fan speeds with the pull chain
to the right of the reverse switch. Start at the OFF
position (no blade movement). First pull will set the fan
to HI. Second pull will set the fan to MEDIUM. Third pull
will set the fan to LOW. Fourth pull will re-set the fan to
OFF setting. Test light with the pull chain to the left of
the reverse switch. (
Refer to
diagram 1
.
) If fan and/or
light do (does) not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (
diagram 2
)
- UP position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely
UP
or
completely DOWN
for fan to function. If the reverse
switch is set in the
middle
position (
diagram 4
), fan will
not operate.
Attach pull chain extensions supplied or custom pull
chain extensions (sold separately) to ends of the pull
chains.
diagram 2
diagram 3
diagram 4
diagram 1
motor
housing
