Liteville 301 Mk15, Руководство пользователя, Страница: 8 / 15

- 14 - - 15 -
• Cut the new cable housing at a 45° angle and
slightly fold it. Thereafter, insert the new cable
housing above the Horstlink at the rear end of
the chain stay.
• Pull the new cable housing out of the front end
of the chain stay until the rest at the end of the
frame leading to the rear derailleur has the
right length. Turning it simplifies the process.
• Entirely slip the PE tube over the cable
housing until it reaches into the chain stay
for about 2 cm.
• Remove both swing arm screws and separate
the chain stays from the main frame. Push
the cable housing into the right-hand opening
of the frame and have it exit again at the
ServicePort.
• Mount the chain stay again and push the
housing further into it making sure it does not
bend.
• Starting at the front, slip the foam tube over
the cable housing until it reaches the inner
main frame.
• With the help of the Park Tool IR-1.2 or the
RockShox Barb Connector, the cable housing
including the foam tube can be guided through
the down tube and into the left-hand cable
hole at the top of the tube.
(-> brake hose routing)
11. Exchanging the housing of the rear derailleur
• Remove the old housing, the PE tube between
the chain stay and the main frame and the
foam tube.
Make sure the housing is underneath the cable pulley.
9. Cable routing front derailleur
• Guide the cable housing from the top right-
hand opening into the down tube and all the
way down to the ServicePort.
• Starting at the ServicePort, push a foam tube
over the cable housing and have the housing
exit the frame at the opening for the front
derailleur.
• Attach the bottom end of the housing to the
front derailleur.
10. Cable routing rear derailleur
The housing of the rear derailleur has been
inserted into the frame already.
• Guide the rear end of the housing to the rear
derailleur and attach it to the intended socket
at the Horstlink using a cable tie (Pos. 14).