LiteSheet Solutions
Page
3
of
4
Preparation
1.
Turn off power source.
2.
Remove luminaire from packaging.
Installation
1.
Drill out (4) pilot holes on BriteCor luminaire
flange to 3/16” dia
meter.
2.
While holding the BriteCor luminaire to the
desired surface, mark the drilled hole locations
on the surface. Remove the BriteCor luminaire
and use a screwdriver to install anchors.
NOTE: For hard wallboard or double board
construction, pre-drill 3/16
” hole i
n the
mounting surface before inserting anchors.
Anchors not needed for mounting to wood.
