Pagina 6 di 8
UP
Down
Enter
Esc
Signal Control Connection
Lites F200 can be operated via either DMX512A and or RDM ready . For dasy chain connection use a -2 x 0,5
mm²
size lead wire plus shield. Connect Pin 1 to ground, 2= data – while Pin 3 = data +. Pins 4 & 5 are not connected.
Ensure that DMX wires and shield do not interfere,nor touch each other as well as they must not touch/interfere with
the body of the unit . (DMX connectors are not provided)
Important note: when DMX is available a red dot will illuminate on the left hand of the display.When
red dot is off no DMX signal is available.
WARNING ! Before powering Lites F200 ensure that all installation(s) procedure(s) have(s) been
properly set and accomplished
DMX OUT
DMX IN
Projector mode settings
When Lites F200 is powered, setup-display will show the software release version The UP, DOWN,
ENTER and ESC buttons will allow the operations of the Lites F200 menu. UP and DOWN buttons
allow to scan menu options, ENTER button allow to select. The ESC button is to retun to the
previous menu or to quit the previous setting.
Menu items
Displayed
message
Allowed or
displayed
values
Mode
Addr
001..510
DMX address : as of 1 to 511
Auto
(Automatic
mode)
co01
co02
co03
co04
co05
co06
co07
co08
co09
co10
co11
co12
Preset 1 red
Preset 2 orange
Preset 3 yellow
Preset 4 c light green
Preset 5 green
Preset 6 cyan
Preset 7 light blue
Preset 8 blue
Preset 9 dark blue
Preset 10 fuchsia
Preset 11 magenta
Preset 12 white
Preset 13 Amber
Values between co001 through co13 allow
for fixed white set-up without DMX 512
protocol signal. When fixture is turned, the
last selected preset will be held
Pr01
Pr02
Pr03
Pr04
Pr05
Pr06
Pr07
Pr08
Program 1: auto
Program 2 : auto
Program 3: auto
Program 4 : auto
Program 5: auto
Program 6 : auto
Program 7: auto
Program 8 : auto
Automatic mode without DMX 512
Protocol signal.
Program selections run between Pr01
through Pr 08
Both programs can be modified. To
change program select Enter then view
(Scn0…Scn9; max scenes of each
program). Clicking on enter once more
it shows P.00.0 (time) followed by
F.00.0 (speed) and ultimately the last
view shows 1c.01… though c12 (colour
to be assigned to each scene) The use
of UP/Down keys allow for setting
values. When selections are completed
press enter to confirm
MaSL
Master Mode
The Master Mode uses the same settings as the
Auto Menu. The only exception is that when all
fixtures are connected to DMX 001 in daisy-
chain, they perform the same presets and or
the same presets selected on the Master fixture
XLR
5
connection
leads description
1
GND
2
DMX-
3
DMX+
4
NC
5
NC