WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested
prior to shipment and are warranted against defective materials
and workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc.
at (516) 931-2800 and the item returned to Liteway, Inc. 166
Haverford Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc.
will then, at its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired
by unauthorized personnel will not be covered by this warranty.
Any non-warranty repairs required will be quoted at the current
rate for such services.
Important Notices
CAUTION !
AVOID DIRECT EXPOSURE TO BEAM
.
All -7,-8, and -9 Models use laser diodes. These solid-state laser diodes
are located in the optical ports of these units. Laser diodes produce
invisible radiation that may be harmful to human eyes. Never look
directly into the optical port of any fiber optic unit designed to operate
with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of any
kind.
© Copyright 2017 Liteway, Inc.
125480 Rev D
OPERATING INSTRUCTIONS
Fiber Optic MIDI
Transmission System
Models;
MIDI-2101-x Transmitter
MIDI-2201-x Receiver
The MIDI-2101/2201 system consists of
the MIDI-2101 transmitter and MIDI-2201
receiver. This system will transmit all
standard MIDI 1.0 data signals over
beyond the specified 50 foot (15 meter)
limit without signal loss or interference
between the two MIDI units.
Technical Specifications
Bandwidth
DC – 1.0 Mb/s (Includes 31.25 Kbaud)
Protocol supported
MIDI 1.0 (all formats)
Rise / Fall Time
Less than 100 nanoseconds
Bit-error Rate
1 x 10-9 (worse case)
Signal Connectors
5 pin 180° DIN
Input Isolation
Optical Isolation 10 KV/us
Output Drive
25mA maximum (5 times MIDI 1.0)
Operating Wavelength
850 (-1), 1300 (-3,-7), 1550 (-9)
Optical Output
-15 dBm typical
Optical Loss Budget
0 – 10 dB
Optical Connectors
Multimode fiber models (-1, -3) ST/PC,
Single-mode fiber models (-7,-9) FC/PC
Temperature Range
-35º to +75ºC
Power Requirements
11-24 VAC/DC @160 mA
Physical Size (mm)
5.0”(127)L x 1.0” (25.4)W x 3.0”(7)D
All specifications measured with 1Km of 62.5u multimode fiber.
All specifications are subject to change
without
prior
notice.
!
