WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested prior
to shipment and are warranted against defective materials and
workmanship for a period of five full years from the date of the original
shipment. Should a problem occur, a Return Material Authorization
Number (RMA) must be obtained from Liteway Inc. at (516) 931-2800
and the item returned to Liteway, Inc. 166 Haverford Road, Hicksville,
NY 11801, USA, prepaid. Liteway Inc. will then, at its option repair or
replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the cost
of the defective item only. No contingent liabilities of any kind are either
assumed or implied.
Any items returned to Liteway, Inc. that have been misused, abused,
damaged, modified, connected or adjusted in any way contrary to the
instructions furnished by Liteway, Inc. or repaired by unauthorized
personnel will not be covered by this warranty. Any non-warranty
repairs required will be quoted at the current rate for such services.
Important Notices
CAUTION !
AVOID DIRECT EXPOSURE TO BEAM
.
All -7,-8, and -9 Models use laser diodes. These solid-state laser diodes
are located in the optical ports of these units. Laser diodes produce
invisible radiation that may be harmful to human eyes. Never look
directly into the optical port of any fiber optic unit designed to operate
with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of any
kind.
©
Copyright
2017
Liteway,
Inc.
106724
Rev
F
OPERATING INSTRUCTIONS
Distribution
Amplifier
Model VM-1004
The VM-1004 is a single input, quad output wide-band video
distribution amplifier designed for those applications where a single
video source must be routed to four separate locations. Although not
a fiber optic system per se, the VM-1004 may be used with any fiber
optic transmission system where multiple video signals are required.
Technical Specifications
Video Bandwidth
DC to 100 MHz
In/Out Impedance
75 ohms
In/Out Signal Level
1 volt peak to peak
Signal/Noise Ratio
75 dB minimum
Differential Gain
0.5% maximum
Differential Phase
0.5º maximum
Output Channel Isolation
>40 dB
Signal Connectors
BNC
Indicators
Power, Signal, Alarm
Temperature Range
-35º to +75ºC
Power Requirements
11-24 VAC/DC @150 mA
Physical Size (mm)
5.0”(127)L x 1.0” (25.4)W x 3.0”(7)D
All specifications measured with 1Km of 62.5u multimode fiber.
All specifications are subject to change without prior notice.
!
