www.litehawk.ca
R
How to charge the Litehawk BURST AUTO:
Forward Flip:
Hold the right stick
forward once and your
BURST AUTO will do a
forward flip.
Right Flip:
Hold the right stick to the
right once and your BURST
AUTO will do a right flip.
Left Flip:
Hold the right stick to the
left once and your BURST
AUTO will do a left flip.
Backward Flip:
Hold the right stick
backwards once and
your BURST AUTO will do
a backward flip.
Flip Mode:
Press once and you will hear one beep - you are
in Regular Mode. Press again and you will hear
two beeps - you are now in Flip Mode.
In Flip Mode you can use the RIGHT control stick
to flip forwards or backwards and to flip left or
right.
Your LiteHawk BURST AUTO comes with a LiPo battery which is inside the model. The
rechargeable Li-Po battery provides the power to propel your model at high speeds. You
should expect 5-8 min run time. However you do need to make sure to properly maintain
your Li-Po Battery.
- Li-Po batteries don’t like to be run down too low. If the voltage is dropped dramatically
they will be damaged and will not recharge! Once the model starts to slow (the lights will
also begin to blink on BURST AUTO), fly your model to a safe place, walk over and turn it
off.
- It is recommend to charge the battery after your run and to always store the battery with
a charge. Never discharge or dead short a Li-Po battery!
Always have your model turned off and the battery unplugged when not in use.
You will notice that there are 2 plugs with wires coming out of the battery. The
larger white plug is the balance plug. This is the plug you use with the supplied
balance charger. This is a keyed plug and will only go in one way.
You MUST unplug the battery from BURST AUTO when charging!
1/ Plug the USB into your computer, TV, or USB charger. The LED light on the USB will turn
RED.
2/ Open the hatch on the bottom of the BURST AUTO by pushing on the grip tab. Gently
remove the battery from the compartment. Unplug the battery from connector in the BURST
AUTO. Make sure the BURST AUTO power switch is turned OFF.
3/ Plug the BURST AUTO battery into the power supply cable. Do not force the plug, it only
goes in one way. The LED light on the USB will turn OFF.
4/ Charge time can take up to 60 minute (less if charging for the first time). Once charged
the LED light on the USB will turn back on to RED.
For more tips visit us at www.litehawk.ca
Tip: If storing for more than 24 hours it is best to store with a fully charged battery.
Failure to do so can damage the battery pack and shorten its useful life.
- Always remove the battery from the toy for charging.
- Unplug the battery from the toy if storing for more than 24 hours.
LiteHa
wk BURST A
UT
O Instruction Manual
6
