CX-410
DIGITAL 4 CH CHASER
SET-UP
DMX SET- UP
Splice a DC 9V adapter to a DC socket. Connect the mic. cable to of the LPX connector.
Connect a 5 pin mic. cable from the DMX output connector to transfer DMX signals to the dimmer.
LPX SET- UP
Connect a 3 pin mic. cable from the CX-410 digital LPX output to the one of Lite-Puter Digital power
pack input. DC power is connected through pin #2. So when connected to Lite-Puter Digital power pack,
no other DC input is required.
LPX signals are automatically connected to pin #2.
DMX LPX
PIN #1.) GND PIN # 1.) GND.
2.) DATA- 2
1
2.) V+ 15V
5 1 3.) DATA+ 3.) LPX out
4 2 4.) NC
3 5.) NC 3
.
OPERATION
CHASE
There are total of 16 chase programs. Adjust the dip switch (
❷
-
❺
)on the CX-410 to match the dip switch
pattern illustrated in the CHASE PATTERNS chart (see drawing below) for the desired chase pattern. If a
different direction is desired for running the program, move the direction switch(
❻
) accordingly.
AUDIO
There is a built in mic in the CX-410. If a direct line is desired, connect a line from the audio source to the
audio input(
❻
) in the back of the CX-410. there are 3 audio modes to select from Audio sensitivity can be
adjusted by turning the audio knob
LEFT (0) = Off
MIDDLE (1) = Chasing speed controlled by audio
RIGHT (2) = Both Chasing on/ off and speed are controlled by audio
DIMMER
Total dimmer intensity can be adjusted by turning the dimmer knob.
STROBE
There are three strobe modes (See general functions #13)
www.audiovias.com
