Dive Computer
User Manual
Liquivision Products, Inc
-
57
-
Revision 1.9 Software 1.17
Your current gas is shown on the bottom left of the screen
Gas
The
gas
alarm will be displayed in the same place as your gas label, and it
will blink. This is because you have exceeded the maximum PO2 of that
gas.
Gas/PO2/CNS
The
PO2
alarm is triggered if the gas you are breathing has a higher PO2
than 1.4. This alarm threshold of 1.4 can only be changed if you enter Tec
mode (not recommended unless you are properly trained). An example of
the PO2 alarm would be if you are diving 40% nitrox, and you dive to
30m/100ft, your PO2 would be 1.6 (which is more than the threshold of
1.4) and the alarm would go off.
The
CNS
alarm will be displayed if you have exceeded your CNS limit.
For more information on this alarm, please refer to the
section of the manual.
The current temperature of the surrounding environment is displayed in the
lower-left-hand corner, next to the battery indicator.
Temperature
It is displayed either in Celsius or in Fahrenheit, depending on your Units
setting (refer to the “
” section of the manual for details). You will see
a “C” or “F” letter next to the temperature value to let you know which
units you have selected.
Keep in mind that the temperature sensor is inside the KAON unit, so it can take many minutes for it to
adjust to a rapid external temperature change.
