P. 2
GENERAL INSTRUCTIONS
This Manual covers the “3” and “H” series Sealed pumps.
Upon receipt of your Liquiflo pump verify:
A)
The equipment has not been damaged in transit.
B)
The pump model number and serial number are stamped on the pump's rear housing.
Model:_______________________ Serial No.____________________
NOTE:
By adding a K prior to the pump's model number a repair kit can be obtained
which consists of the following parts: drive and idler gears, drive and idler shafts, retaining
rings, wear plates, keys, housing and bearing lock pins, o-rings and bearings.
SYMBOL EXPLANATION
A)
Work Safety Symbol
This symbol indicates remarks applicable to operational safety,
where risks for health and life of personnel may be posed. All
cautions should be passed on to other users.
B)
Attention Symbol
Special attention must be paid in order to maintain a correct
operating procedure and to avoid damage to the pump and/or other
plant equipment.
INSTALLATION OF PUMP AND MOTOR ASSEMBLY
All items included in this section.
The following should be observed for proper installation of the pump.
A)
Pump should be accessible for servicing and inspection.
B)
The foundation area should be rigid and level for maintaining pump alignment.
C)
The inlet should be as close to the liquid source as practical and preferably below it.
D)
Piping should be supported. Do not use the pump as a pipe hanger.
E)
Install valves and unions to isolate the pump during maintenance.
ATTENTION
ATTENTION
!
RECORD
