Customer Training Guide
Pre-Launch Wave Glider® SV3
08033 Rev A
4
Note: If you do not see a vehicle on WiFi, you can turn it on with SV3 Commands
WiFi ON/OFF = SV3 Commands - Services - wirelessAccesPoint - Com channel
Cell/Iridium - WIFI On - WIFI Off
Virtual Relay:
Auto filled
WGMS
– Click vehicle icon – Click Raw Outputs – in left hand column check for VR Cell.
WGMS Iridium:
Auto filled
WGMS
– Click vehicle icon – Click Raw Outputs in left hand column – Iridium will be in
the same section that VR Cell is. It will be labeled IridumStatus under Structure Type.
Under the IMEI section it will be labeled by a combination of numbers.
Note: Iridium will always be on. This way if the Wave Glider goes out of Cell range it will
maintain communication
OBSP - Setup
– All Vehicle Parameters – Enable – Look for Iridium Modem – Box
checked = ON
OBSP
– Status – Amps – Host Domain – Slot 32 #1 – View if ON or OFF
Note: Always power up the Wave Glider outside (Clear view of sky). When an SV3 is powered
on Iridium is defaulted to ON. This will also allow the default GPS system to boot up properly.
DO NOT SET DEFAULT COMM CHANNEL. THIS WILL CAUSE VERY SERIOUS ISSUES!
Vehicle Telemetry received:
WGMS- First information box when scrolling down (Communications)
– If all 0.00 It will
be an alarm.
– If there is information double click it to see if it was sent via Cell or
Iridium. This information can also be viewed from the vehicle icon - telemetry tab.
Tracker Telemetry received:
Xeos Resilient Tracker
:
(White & Black tracker in bow, also known as the Resilient
Tracker) WGMS
– Click the drop down menu (searching for gliders and trackers) - By
default;
Resilient Trackers will be labeled with a “Res. Tracker”. The numbers are the
last four of the tracker’s IMEI, which can be found printed on the tracker. Information