Lippert Power Step 2.0, Руководство пользователя

Страница: 4 / 8

Rev: 01.07.22
Page 4
CCD-0005465
Operation
If the vehicle is driven with the step in the extended position, there is the possibility of causing major
damage to both the step and the coach. Always make sure that the step is fully retracted before traveling. If
the step is left extended and strikes an obstruction while the vehicle is moving, major damage to both the
step and the vehicle could result.
Stepping on a partially extended step may cause damage to the step frame. Do not use the step until
the step is fully extended.
If the vehicle is driven with the step in the extended position, product and/or property damage
may occur.
NOTE: If the yellow wire from the 4-way connector is NOT connected to an ignition power source, the
ignition safety system will be inoperative and the step will remain in the extended position. In this
case, the override switch MUST be turned off for the step to retract.
NOTE:
If the yellow wire from the 4-way connector is not connected to an ignition power source, the step
will
NOT
retract with the step in the override "on" position when the door is closed and the ignition
is on.
1. Open the entrance door then turn the step override switch to the "off" position.
A. Close the door.
I. The step should retract and lock in the up position.
II. The under-step light will be off.
B. Open the door.
I. The step should extend and lock in the down position.
II. The under-step light will be on.
NOTE:
The under-step light is on when the step is extended and off when the step is retracted. If the coach
door/screen door is left open, the light will turn off after five minutes.
2. Turn the step override switch to the "on" position.
A. The step should remain in the extended position when the entry door is opened and closed.
B. The under-step light will turn off when the door is closed and on when the door is open.
3. With the step override switch turned on, the step extended and the entrance door closed, turn the
vehicle ignition on.
A. The ignition override system will go into effect.
B. The step will automatically retract.
NOTE:
If the yellow wire from the four-way connector is not connected to an ignition power source, the
ignition safety system will be inoperative and the step will remain in the extended position. In this
case, the step override switch
MUST
be turned off for the step to retract.
4. Turn the vehicle ignition off and open the door.
A. The step will extend and lock in the down position. This is the Auto Extend feature.
B. When the vehicle ignition is turned on, the step will activate with the door movement, regardless
of the step override switch position.