3
432-LIPPERT (432-547-7378)
Rev: 07.12.22
Thin Shade
For Lippert RV Entry Door
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001507
7.
Holding the bottom rail at an approximate 45 degree
angle, insert one end into the corner between the inner and
outer frame
(Fig.2B)
.
8.
Repeat this action on the opposite end of the bottom rail.
9.
Press both ends down and latch in place, moving levers
in a left-to-right direction.
Fig.3
A
B
Fig.2
Installation - Screw-in Frame
NOTE:
Door must be equipped with #387501 inner frame.
1.
Working from the bottom of the shade, locate the bottom
rail
(Fig.3A)
.
2.
Remove end caps.
3.
Locate the knots tied at the end of each cord
(Fig.3B)
.
bottom rail
end cap
end cap
1/2
”
A
B
FAILURE TO FOLLOW THE RECOMMENDED
PROCEDURE OF REMOVAL COULD RESULT IN
PERSONAL INJURY FROM BROKEN GLASS OR
DAMAGE TO EQUIPMENT. IT IS IMPORTANT TO
REMOVE THE PHILLIPS HEAD SCREWS IN THE ORDER
STATED.
4.
Measure
1/2
” up from the existing knot and mark the
cord.
5.
Repeat this action on the opposite cord.
6.
Create a new knot on both cords, at the marks made in
step 4.
7.
Pull bottom rail of shade down to the newly created
knots.
8.
Replace end caps.
