7
lci1.com
574-537-8900
Rev: 04.03.20
Solera
®
Universal Hardware
Power Awning to
Solera 12V Power Awning
(For Aftermarket Application)
CCD-0001282
8.
With additional assistants holding the support arm
assembly, remove the upper fasteners from the drive side
mount arm
(Fig.6)
. Pull the nylon ties tight.
9.
Detach the drive side support arm assembly from the unit
and roll tube and set aside.
10.
Place the Solera end cap
(Fig.7B)
on the end of the roll
tube
(Fig.7A)
, making sure it is properly seated and the roll
tube channel is aligned with the channel on the end cap.
NOTE:
When determining the drive head assembly from
the idler head assembly, the drive head assembly will have
an override plug
(Fig.8C)
, whereas the idler head assembly
will not.
Fig.6
A B
Fig.7
A
B
C
Fig.8
13.
Align the holes and secure with the provided
#8 - 32 x
1/2
” wax screw
(Fig.9)
.
NOTE:
Keep the head of the wax screw
1/8
” from
fastened to avoid compromising the structural integrity
of the wax screw.
11.
Secure the Solera end cap to the roll tube with the
provided rivets.
NOTE:
It may be necessary to drill out the previous holes in
order to accommodate the larger-sized rivets.
12.
Insert the Solera drive head assembly shaft
(Fig.8B)
into the end cap
(Fig.8A)
.
14.
Place the drive side support arm assembly directly
under the awning rail so the top of the mount arm is
touching the bottom of the rail.
15.
Align the drive side support arm assembly with the
corresponding guideline marked in Step 1, being sure all
previous holes are covered.
Fig.9
