6
lci1.com
574-537-8900
Rev: 08.20.20
CCD-0003866
Flow Max
™
40V Portable Power Cleaner
Installation and Owner’s Manual
(For Aftermarket Applications)
Selecting Modes
Battery pack should be disconnected prior to selecting
appropriate operational mode. This is to ensure safety
and limit unintentional use while the nozzle is pointed at
the user.
1.
Press the trigger lock
(Fig.13A)
located on the left side
of the handle assembly’s trigger. This will push the lock
button outward on the other (right) side of the trigger,
resting against the handle to prevent the trigger from
unintentionally activating.
A.
Zero-degree (0°) mode emits a single, steady stream
of water that should only be used on hard surfaces, such
as concrete or steel.
B.
Twenty-degree (20°) mode emits a horizontal, 20-deg
spread of water.
C.
Twenty-degree angle (20°) mode emits a horizontal,
downward 20-deg spread of water.
D.
Forty-degree (40°) mode emits a horizontal, 40-deg
spread of water.
E.
Foam mode pulls material from the additive bottle and
mixes it with the supply water to emit a foamy spray.
NOTE:
Material inside the additive bottle is only dispensed
when the power cleaner is set in Foam or Shower mode.
Material will
NOT
be dispensed through any other mode
setting.
F.
Shower mode pulls material from the additive bottle
(when attached) and mixes it with the supply water to emit
a foamy spray in a cone-shaped stream of multiple water
jets, much like a bathroom shower head.
NOTE:
LCI does
NOT
recommend using the additive bottle
in Shower mode.
3.
If using the 360-degree nozzle, make sure the nozzle
end is pointed straight out prior to operating.
NOTE:
The 360-deg nozzle is best used to clean difficult
to reach areas, such as tough corners, tire rims and
wheel wells. The nozzle end can pivot 180 degrees and
when adjusted by rotating the wand, 360-deg capability
is achieved.
DO NOT USE ZERO DEGREE SETTING ON PAINTED
OBJECTS, SOFT WOOD SURFACES OR THIN PLASTIC
OR FABRIC SURFACES. WATER PRESSURE AT ZERO
SETTING ON SUCH SURFACE AND MATERIAL CAN
CAUSE PROPERTY DAMAGE. SELECT A LOWER
PRESSURE AND WIDER SPRAY SETTING TO CLEAN
SUCH SURFACES AND MATERIALS.
DO NOT DIRECT OPERATING POWER CLEANER
NOZZLE AT PEOPLE OR PETS. THE WATER PRESSURE
JET STREAM CAN CAUSE PERSONAL INJURY TO
UNPROTECTED FACIAL AND EXPOSED SKIN AND
SEVERE DAMAGE TO PETS.
DO NOT OPERATE NEAR AN ELECTRICAL POWER
SOURCE SUCH AS AN ELECTRICAL OUTLET OR
WIRING. SPRAY CONTACTING ACTIVE ELECTRICAL
COMPONENTS CAN CAUSE PERSONAL INJURY FROM
AN ELECTRICAL SHOCK OR BURN.
2.
With the 6-position nozzle attached, select an
operational mode by rotating the end of the wand assembly
to the desired mode.
Operation
A
Fig.13
