Instructions
Compact disc mower KSM 130
19 - 22
140050-01-EN BA KSM 130 / 04.06.2020
Attention!
Removing the angular ball bearings will destroy them and
make it necessary to replace them in any case!
Do not forget the spacer rings between the bearings!
Replacement of the idle wheel and the ball bearings inside the
cutter bar
This is done by unscrewing all screws to remove tray and lid. Only
the cutter disc and the bearings do not have to be unscrewed. Then
push the idle wheels along with the ball bearing away by using two
tire levers. The ball bearing is held in the cogwheel by means of a
retaining ring. The ball bearing can be pressed out of the cogwheel
by applying a pressing force of 5 tonnes. This will only destroy the
retaining ring.
15. After use
If the
LIPCO Compact disc mower
is to remain unused for a longer
period, it is necessary to carry out the following steps:
•
Thoroughly wash and dry the
LIPCO Compact disc mower
!
•
Check the function of all movable parts. Replace damaged or
worn parts!
•
Check the tightening of the screws!
•
Lubricate free wheel and universal joint shaft!
•
Check oil in the angular gear and in the cutter bar!
•
Grease all unpainted metal parts to protect them against
corrosion, cover the
LIPCO Compact disc mower
and store it in a
dry place so that it will be ready for use any time!
•
Attention!
When putting the device back into operation, please follow the
instructions in chapter “11. Maintenance”.
Содержание KSM 130
Страница 22: ...22 22 Design mail bauer ib com...