36
Locking your locomotive into a single direction
W
hen the Command reverse unit switch is in the RUN position on the powered unit, your loco-
motive sequences through a repeating pattern of operations: forward, neutral, reverse, neutral,
and so on.
To “lock” your locomotive into a single direction (for example, to operate in forward
only), you can deactivate the Command reverse unit’s sequencing function.
1. Use your transformer’s DIRECTION button or interruptions in track power
to get your locomotive moving slowly in the desired direction or into
neutral.
2. Slide the Command reverse unit switch on the powered unit to the PGM
position. At this point, the locomotive is “locked” into your chosen
direction. See Figure 4 on page 9 for the location of this switch.
To restore the forward-neutral-reverse sequence, just slide the Command reverse unit
switch back to the RUN position.
Conventional transformer operations
Reprogramming your locomotive to restore features
I
f your locomotive is unresponsive to your commands in the Command Control environment, we
recommend that you follow this procedure to reset your locomotive. All factory default settings will
be restored when you reprogram the locomotive.
1. Slide the program run switch to the PGM position.
2. Plug in and connect your LEGACY Base.
3. Place your locomotive on the track, then power up the track.
4. Press ENG and enter the locomotive’s ID#.
5. Press SET.
6. Turn off track power and wait ten seconds.
7. Slide the program run switch back to the RUN position.
At this point, your locomotive has been reset. Restore power to the track and operate the
locomotive as usual. Be sure to use the ID# entered in Step 4.
