N
ow you’ll need to insert a controller
wire into each of the two spring clips on
the lockon.
It’s easy! Depress the spring clip with your
finger and insert the bare end of the wire
into the exposed opening. Release the spring
clip. Give the wire a little tug to make sure
it’s secure. Repeat these steps with the other
spring clip. The wire attached to position 1
on the lockon should be fastened to termi-
nal post A on the 80W controller. The wire
attached to position 2 on the lockon should
be fastened to terminal post U on the 80W
controller. Next, insert the small plug end of
the power pack into the back of your con-
troller, and plug the other end into a stan-
dard outlet.
If the horn and bell buttons on
your controller do not control the
correct sounds, remove the wires from the
lockon and reinsert each one into the oppo-
site clip to reverse the polarity.
Note!
Make sure that the bare end of each wire is securely
attached to the spring clip and that the two wires do
not come in contact with each other.
Attaching the controller wires to the lockon
Controller operations
6
Stripping the wire
O
nce your
track is
assembled and
the lockon is securely
attached, you can
connect the wires
from the controller
to the lockon.
First you’ll want to check the ends of the
wires to make sure that the insulation is
stripped back about 1⁄4" to
3⁄8". To strip the
wires, use a pair
of wire strippers
or a sharp knife.
Caution: Only an
adult should perform this task!
Always use care when strip-
ping wires.
