8
Stack Smoke
Loading smoke fluid
into the smoke stack
will provide
smoke fluid for the stack smoke effect.
When adding fluid DO
NOT EXCEED 20 DROPS per unit
as this can cause your
smoke unit to become oversaturated allowing leakage onto the
electronics. Note that operating your locomotive's smoke unit
without smoke fluid will cause damage to the heating element.
Add 20 drops initially and 10 to 20 thereafter, as required to
maintain desired smoke.
Your locomotive's smoke fluid consumption will vary
depending on the smoke level setting you have selected.
Note!
Figure 5. Stack smoke location
Locomotive basics
Refer to Figure 5 as you add the smoke fluid. If you prefer to operate your locomotive without
smoke, locate the smoke unit switch under under the cab of the locomotive and slide it to the OFF
position. Refer below for the location of the switch.
T
he functions of your LionChief Plus 2.0 locomotive's switches are outlined below.
The
instructions below are specific to this particular locomotive; note that
available features (and switches) may differ from other locomotives and
sets.
Locomotive switch locations
Smoke Switch
Used to turn the smoke unit on
and off.
Program / Run Switch
Used to assign an ID# and
reprogram the locomotive in
Command operation when the switch
is in the PROG position. Also used to
“lock” your locomotive in a single
direction, or neutral, in conventional
operation when the switch is placed
in the PROG position.
Bluetooth Switch
Used to turn the Bluetooth
module on and off.
Adding fluid to your locomotive’s smoke generator continued
Figure 6. Switch locations
BLUETOOTH
ON
OFF
BLUETOOTH
OF
F
ON
RUN PGM
RUN PGM
SMOKE
O
N
OFF
SMOKE
O
N
OFF
