Wiring your CW-80 Transformer
5
f
or best performance on large layouts, it is recommended that you use 16-gauge wire to
connect your CW-80 Transformer to the track. Use the stripped ends of the wires, or spade-
shaped connectors on all CW-80 Transformer connections, with no more than two wires on each
terminal. Terminal strips (available at your local electronics supply store) allow you to connect
multiple wires to evenly distribute power to your layout.
Make sure that all connections are secure. Loose connections can produce extremely high
temperatures. For this reason, do not touch the terminals or track connections during use.
Also, do not locate scenery materials such as lichen or ground foam near the terminals.
To prevent the excessive build up of heat, be sure to select the proper wire gauge
for your layout. Follow these guidelines:
• Track connections (or Lockon connections) must be made with 18-gauge wire
or heavier. Larger layouts require a minimum of 16-gauge wire.
• Use 24-gauge wire only when connecting single accessories that require lower
current.
• When wiring multiple accessories (two or more) or accessories that require
higher current, be sure to use 18- to 16-gauge wire.
1. Attach a Lionel Lockon to your track.
As illustrated in Figure 1, slide the bottom edge of the outside rail into the metal lip on the
Lockon. Press the clip at the end of the Lockon over the bottom edge of the inside rail.
2
1
LIONEL
CTC
LOCKO
N
Figure 1. Lockon attachment
Caution!
