Lionel Allegheny Steam Locomotive, Руководство пользователя

Страница: 21 / 32

21
TrainMaster Command Control operations
CAB-1 Remote Controller numeric keypad commands
W
hen you press the AUX1 button on your CAB-1 Remote Controller, you turn the numeric
keypad into ten command buttons. After you press the
AUX1
button, you will be able
to press any numbered button until you address a different product. The corresponding
RailSounds sound system effects are in italic type.
Stops and resets the locomotive. Resets the locomotive’s direction to forward.
Your locomotive keeps track of its coal and water levels. Higher engine speeds and/or heavy
labor will use fuel at a faster rate. Like a prototypical steam locomotive, water is consumed
at a faster rate than coal.
To add both coal and water, perform a "long reset." Press and hold
AUX1, 0 for at least
three seconds. You will hear the sounds of coal pouring into the tender as long as you hold
the button. When you release the button, the sounds will stop and the engineer will confirm
that the tank is full.
Refueling sequence.
Raises the overall master volume of the LEGACY RailSounds sound system. To
independently adjust the level of the background sounds only (e.g., the chuffing and steam
hiss), tap
AUX1
and then this key. Sound volume increases.
When adjusting the overall volume, you'll hear a single bell hit that gets louder or softer
with each volume adjustment. When the volume is at maximum, additional button
presses have no effect and won't play the bell. When adjusting the background sounds
(
AUX1
, then a volume key) you'll hear the volume change without a single bell hit.
Engineer begins radio dialog, dispatcher replies (see page 16). To hear the engineer say the
current level of coal or water and current speed, press
AUX1
,
2
or
AUX1
,
CrewTalk
while
the engine is in motion. CrewTalk communication.
In motion, plays the sound of injector transferring water from the tender to the boiler. At
a stop, plays the sound of a water tower spigot arm lowering, then water gushing from the
tower to the tender, which also "refills" the virtual water level in the tender and plays a
confirming radio dialog.
Water injector/water tower sounds.
Lowers the overall master volume of the LEGACY RailSounds sound system. To
independently adjust the level of the background sounds only (e.g., chuffing and steam
hiss), tap
AUX1
and then this key. Volume settings are retaining when track power is
turned off. Sound volume decreases.