LINTECH
–
1 avenue de Norvège
–
91140
–
Villebon sur Yvette
Tél : 01 64 86 70 90
–
Fax : 01 64 86 70 80
Icons definitions
1.
: video mode
2.
: The microscope is recording
3.
: The microscope is taking a picture
4.
/
: with/without TF card
5.
: Still image mode
6.
: review mode
Quick start
1.
To use the microscope without the need for a computer, then connect the optical stack
to the power supply via the switch cable.
2.
Then press and hold the Power button (number
①
from the picture
“Buttons”
)
underneath the display until the display turns on. (It may turn on automatically, and it
’
s
totally fine.)
*Troubleshooting
If the display freezes, locate the “
reset
”
hole on the back of the monitor. Use a narrow
object such as an unfolded paperclip to depress the button located inside. This resets all
settings to their factory values and restarts the display . It does not erase saved images or
video.
Adjusting the Magnification and Focus
Use the large knobs on the optical bracket to raise or lower the optical stack to the
desired height. The lower the height, the greater the magnification, but be careful not to
let the bottom of the stack contact the object being imaged. (Note that you may need to
reposition the spotlights as you move the stack up or down.)
Turn the Focus controller(number
⑨
from the picture
“Buttons”) to focus the image.
To increase the digital magnification, press and hold the Up button ( number
③
/
○
,13
from the picture
“Buttons” ) until the desired digital magnification(up to an additi
onal 4x
beyond the optical magnification) is reached. Use the Down (number
④
/
○
,11
from the
picture
“Buttons”) button to decrease the digital magnification.
