6
There are four sets of speaker outputs on the rear of the LK100. This simplifies the bi-wiring of speakers
such as the Linn INDEX, HELIX or NEXUS.
Whether you are using single speaker cable, bi-wiring or tri-wiring, the 4mm plugs supplied should be
properly soldered to good quality cable. For best results we recommend Linn K20, K400 OR K600
loudspeaker cable which is available through your authorised Linn retailer.
Please note that speaker cable is directional and will perform better when orientated in the proper
direction. linn speaker cable is imprinted with a circular linn logo followed by the model number of the
cable. When the cable is properly orientated, the circular logo will point towards the loudspeakers.
For more information on the performance advantages of bi-wiring, tri-wiring, passive bi-amplifiers and
Aktiv multi-amp systems, consult your local authorised Linn retailer.
There are two levels of electronic overload protection in the LK100. The first is an over-current sensor,
which protects against short circuits on very low impedance loads. The other is an over-temperature
sensor, which protects against inadequate ventilation. The internal temperature sensor shuts the amplifier
down if the sensor reaches 70 degrees centigrade.
To re-set the LK100, switch off and wait until the POWER light goes out (approximately 40 seconds). The
amplifier will re-set itself and resume working.
LOAD IMPEDANCE The LK100 will drive two pairs of 8 ohm loudspeakers or one pair of 4 ohm
loudspeakers. You can use the LK100 to drive two pairs of 4 ohm loudspeakers, but this may cause the
over-current protection trip to operate at moderate volume levels. However, this will in no way damage
your LK100.
OUTPUT CONNECTIONS
THE LINN PERFORMANCE ADVANTAGE
Содержание LK 100
Страница 1: ......
