PAGE 2
PACK 222
KUDOS5.DOC
Mar 97
6. Fit the KUDOS tuner PCB into the MAJIK/WAKONDA :-
(i) Align the mounting plate in the
Sneaky slot aperture,
(ii) Align the two white plastic stand-
offs in their holes,
(iii) Apply a steady even pressure on
top of the extension connector and
near the plastic stand-offs to push
the KUDOS tuner PCB into position.
(See photo 3). Try and keep the
board horizontal whilst pushing into
position. Excessive force is not
required.
7. Fit two M3 screws with shake-proof
washers to hold the mounting plate into
the Sneaky slot. The shake-proof
washers MUST be used to ensure
electrical grounding. Check with Multi-
meter (set to Ohms) for continuity
between earth pin of mains plug and top
of screening can on Kudos board.
8. Remove the facia assembly from the MAJIK / WAKONDA :-
(i)
Unplug the display ribbon cable and the power-on LED connector,
(ii)
Remove the two facia screws underneath and the two countersunk screws at each end,
then lift off the facia.
9. Now working on the facia assembly, remove the four screws and take off the MAJIK / WAKONDA control
PCB.
10. Lift off the grey rubber switch membrane.
11. Snap off the four legs along on the back of the display window along with the rivet washers.
(See photo 4)
12. Push off the MAJIK / WAKONDA display window
along with the control buttons.
13. Remove the four screws and lift-off the MAJIK /
WAKONDA control area mounting plate.
14. Fit the new KUDOS control area mounting plate,
which has extra holes for the additional buttons,
using the existing screws. Ensure the two in-fill
mouldings which are located under the mounting
plate are correctly positioned. (New screws are
included for use if required.)
15. Fit the new 11-buttons assembly by engaging the
return hooks first to ensure they are not damaged,
and then fit the new window to hold the buttons to the control area plate and push firmly into place.
Ensure the protective film can be easily removed, and is not trapped behind the window.
16. Turn the facia over, fit the display legends label over the locating pins and rivet in place by pushing the
push-on rivet washers HARD into place on the pins using a 5 mm Nut-runner. (See photo 5)
Photo 3
Photo 4
