PAGE 1
PACK 222
KUDOS5.DOC
Mar 97
INSTALLATION INSTRUCTIONS
LINN KUDOS SNEAKY UPGRADE IN LINN MAJIK / WAKONDA
1. Unpack and check the contents of your KUDOS Sneaky upgrade kit.
Contents list :- 1x KUDOS tuner PCB
Tools required : No.1 Pozi screwdriver
1x KUDOS control PCB
Small pliers
1x Control area mounting plate
5 mm Nut-runner
2x Nylon Stand offs
Multi-Meter
1x Display window
1x 11-buttons assembly
1x Extension connector
2x Ribbon cables
1x Display legends label
4x Push-on rivet washers
3x Spare M3 screws (black)
2x Shake-proof washers
4x Spare ‘Taptite’ screws (black)
2x Nylon insulating bushes.
4x Shorting links -
1 x Used to disable sleep option (point 21)
3 x Used to configure the KUDOS for use in USA, see page 4)
2. On a clean bench, and with a protective pad to protect the facia, turn the MAJIK / WAKONDA upside down,
remove the four screws and slide
off the outer sleeve.
3. With the MAJIK / WAKONDA sitting
on its feet again, remove the two
screws on the back-panel, and take
off the Sneaky slot blanking plate.
4. Push-fit the two white plastic stand-
offs into the holes in the MAJIK /
WAKONDA main PCB until they
audibly ‘click’ and lock into position.
(See photo 1)
5. Push the extension connector into the holes on the underside of the KUDOS
tuner PCB. (See photo 2) It is important to fit this connector first to the KUDOS
tuner PCB, and not to the MAJIK / WAKONDA main PCB, otherwise the pins may
be damaged on assembly.
Time required :
45 minutes
Use anti-static precautions
including work station. If this is
not possible - Ground yourself!
See Service Manual 5.8 for details
STAND-OFFS
Photo 1
Photo 2
EXTENSION
SOCKET
EXTENSION
CONNECTOR
