11
AKURATE Loudspeaker System
Owner’s Manual
AKURATE 226
English
Parameters
The AKURATE 226 speaker is equipped with eight adjustable parameters (see
next page) that enable you to alter its performance to suit your taste.
Note:
The parameters can only be adjusted when the AKURATE 226 speaker is not in
standby mode.
Adjusting the parameters
To select the parameter you wish to adjust:
●
Hold FEATURE.
●
Repeatedly press UP or DOWN until the letter for the desired parameter
appears.
●
Release FEATURE.
●
Repeatedly press UP or DOWN to change the setting.
A few seconds after the last key press the display
changes to
To restore the default settings:
●
Disconnect the AKURATE 226 speaker from the mains supply and wait for
the display to go blank.
●
While holding FEATURE reconnect the mains supply.
●
Continue to hold FEATURE until the display shows
H
A few seconds after releasing FEATURE the display changes to
HP OUT
AL OUT
A IN
-
-
Operation
When you have made all the required connections, switch on the mains supply.
Flashing bars will be shown on the back panel display for approximately 5
seconds. During this time the speaker’s servo circuitry is stabilising and no
audio will be issued. When the display changes to show the standby symbol (see
table below), the speaker is ready to receive an audio signal.
Whenever the AKURATE 226 speaker is disconnected from the mains supply
and then reconnected, wait until the standby symbol appears on the display
before playing a disc.
Operating modes
SYMBOL
MODE
MEANING
Standby
The unit is waiting for an audio signal
In this mode the unit consumes minimal
power.
On
The unit is fully powered-up
The unit will enter this mode as soon as it
receives an audio signal.
Thermal Standby The unit has overheated
During very demanding, sustained use the
unit will go into Thermal Standby mode in
order to allow itself to cool down. When in
this mode the unit will not produce any
sound. The unit will return to On mode
when its temperature has dropped to its
operating level.
Key to symbols
