Linksys WRT3200ACM, Руководство пользователя

Страница: 5 / 25

(9) ETHERNET 1 through 4 (Primary)— (White) These numbered LEDs correspond with the
numbered ports on the router’s back panel. If the white LED is solid, the router is connected to a
device through that port. A flashing white LED indicates network activity over that port.
(10) ETHERNET 1 through 4 (Secondary)— (White) If the white LED is off, the router is
successfully connected to a device through that port at 10/100 Mbps. A solid white LED
indicates that the router is successfully connected to a device at 1000 Mbps.
(11) WPS Indicator— (White/Amber) The LED blinks slowly for up to two minutes during Wi-Fi
Protected Setup. It will be solid white for five seconds to indicate a successful connection. The
LED blinks amber if the Wi-Fi Protected Setup process fails. Make sure the client device supports
Wi-Fi Protected Setup. Wait until the LED is off, and then try again. The router supports one
session at a time.
Back view
(1) Adjustable antennas
—
This router ships with four adjustable external antennas that should be
connected to the router before powering it on. To connect the antennas, twist the antenna
connector clockwise onto the antenna port on the router.
Note
—
For best performance, position the side antennas vertically as shown in the picture
on the left.
(2) Wi-Fi Protected Setup™ button —Press to configure wireless security on Wi-Fi Protected
Setup-enabled network devices.
5