3
fig.1
fig.2
⚫
The rubber feet shall be mounted on the device firmly.
4.
Requirements of the mounting place:
⚫
The device must be placed on a stable surface according to the instruction.
⚫
Please mount the device on a place where it can be connected to power easily and be maintained normally.
⚫
It is advisable to make the rear of the device 10cm away from wall or other barriers.
⚫
The oven must be placed on a stable table stand or shelf.
⚫
If the device is placed near wall, please make sure that it is away from inflammable objects.
⚫
Please install this device in a well-ventilated place with fine fire extinguishing equipment.
5.
Remove the film on the surface of the device before using.
6.
Electric component connection:
⚫
The connection of power cord must comply with the electrical safety standard.
⚫
Before connection, check whether the voltage and frequency of the applicable power supply correspond with the
parameters on the device data plate.
⚫
Please mount a bipolar switch between the device and the power cord. When the
device is running, the voltage error shall not exceed ±10%.
7.
Power cord connection(fig.1):
⚫
Use an appropriate screwdriver to screw the cable tight and fasten it.
⚫
Connect it according to the connection figure.
8.
Connection of the water inlet pipe(fig.2):
⚫
Connect the tap water pipe joint and the solenoid water inlet with the supplied water
inlet pipe, and add a filter at the side of the tap water pipe joint to prevent the solenoid
from being blocked by sediments.
⚫
The oven is equipped with an exhaust pipe at the back to discharge the excess steam.
Notice:
1.
The device must be grounded.
2.
When connecting the power cord, please abide by the instruction show on the figure: insert the copper bridge and
power cord underneath the screw and then screw the power cord carefully so that the copper bridge can hold the
power cord firmly.
3.
If the connection is incorrect, the connector may generate heat and burn out the power cord.
4.
The supply voltage should comply with the working voltage of the appliance.
5.
The appliance is equipped with an earth bolt at its back, which should be connected with copper wire no less than
1.5mm² and earth wire that conforming to safety regulations reliably.
6.
After installation, check that whether the connection is loose, whether the voltage is normal and whether the safety
grounding is reliable.
7.
The fixed arrangement of wire should be equipped with an all-pole disconnecting switch with a contact opening of
3mm on its poles. It is advisable to install a grounding leakage protection switch. Do not pile up sundries in front of
the switch, for convenient operation sake.
8.
Vicinity of the mounting position should not store flammable or explosive objects. The ambient temperature should
be lower than 45
℃
and the relative humidity should be below 85
％
.
Special Notice
1.
This product is a commercial machine that needs to be operated by trained cook, not applicable for household use.
2.
Do not sway or tilt the appliance during operation.
3.
Do not dismantle or self-modify the appliance. Dismantlement and self-modification may cause casualty.
4.
Do not open the housing of the appliance. The product contains high-voltage circuit, housing dismantlement may
cause electric shock.
5.
Before cleaning, unplug and cut off the power supply.
6.
During cleaning, do not aim at the appliance with water jet. Water can conduct electricity, that may cause electric
shock due to leakage.
7.
Do not pat the product or put any heavy objects onto it. Abnormal operation may cause damage and danger.
