Linhai 2005 ATV 260, Руководство по обслуживанию

Страница: 240 / 341

CHAPTER 5 FINAL DRIVE
ATV SERVICE MANUAL 07.0
CHAPTER 5 FINAL DRIVE. 5- 8
damage and replace if necessary as
described under the Disassembly /
Assembly procedure in this chapter.
2. Move each end of the drive shaft in a
circular motion (and also a reciprocate for
inner one) and check the drive shaft joints
for excessive wear or play.
3. This inner CV joint (inboard pivot joint)
can be serviced if there is wear or play.
The outer CV joint (outboard pivot joint)
cannot be serviced if worn or damage
and if necessary, the drive shaft assembly
must be replaced.
5.6 FRONT DRIVE AXLE INSTALLATION (4X4)
CAUTION
To avoid damage to the front
differential oil seal and the strut oil seal,
hold the front drive shaft horizontal and
straight into the strut during installation.
1. Hold the drive shaft straight in from the
front differential.
2. Push the drive shaft straight into the front
differential and push it in all the way until
it bottoms out. If necessary, carefully tap
on the outer end of the drive shaft with a
rubber mallet or soft-faced mallet.
3. After the drive shaft is installed, pull the
inner CV joint a little to make sure the
drive shaft stopper ring has locked into
the front differential side gear groove.
4. Carefully install the outer CV joint
(spindle) into the strut
，
install the front hub
and wheel.
5. Install the ball joint on the A arm, the
steering tie rods, the hubs and the wheels
as described in this Chapter and Chapter
4.
5.7 FRONT DRIVE AXLE DISASSEMBLY/ INSPECTION (4X4)
INNER CV JOINT DISASSEMBLY
NOTE
The outer CV joint cannot be