Chain tensioners.
When the chain getting loosen,use the tools to adjust the below chain tensioner to adjust it.
Attention!!
This scooter is a mechanical machine and must be properly maintained. Failure to maintain your scooter will result in damage to your scooter or injury to the
rider. Your chain will become loose within the first few rides and will come off if not properly tightened and greased. Your brakes will need to be adjusted after
the first 5-10 full rides.
Charge your scooter after every ride even if it was a short ride
. Never try to completely drain your scooter’s battery. You will damage your battery if it is not charged
after every use. Keeping your battery topped off will insure a long battery life
. Never leave your charger plugged into your scooter for any longer than 24hours.
If the scooter will not be used for more than 30days please charge it at least once per month or fully charge the battery pack then remove it from the scooter and store it in
room temperature. DO NOT connect your charger to the scooter if the battery pack is not plugged into your scooter. Always disconnect the charger before removing the
battery pack and do not reconnect your charger until the battery pack has been plugged back into the scooter. Once your battery is at the end of its life please remember to
RECYCLE IT!! Lead from SLA batteries is detrimental to the environment and poisons our water supply. Please consider replacing your battery with one of our non-toxic
LifeP04 lithium batteries. It is a much higher quality battery and it will not pollute the environment.
NEVER GET YOUR SCOOTER WET.
Water in the wrong place can damage electrical components and cause dangerous electrical malfunctions.
Parents please do not let kids lock up the back tire by applying the brakes to hard. Kids love to do power slides with scooters. This will cause slick spots on the tire and will
also cause a flat. Also do not sit on your seat and put your feet on the deck with the kick stand down. You will bend your kick stand or break the kick stand stop bolt.
The kick stand is designed to support the scooter’s weight; not the rider’s weight.
CHECK ALL NUTS AND BOLTS.
Vibration from riding your scooter will cause some nuts and bolts to become loose and even fall off. Please check for any loose nuts and
bolts before each ride and tighten as needed. Important areas to watch out for are your rear sprocket, disc brakes, and motor mount bolts
Keep your Scooter’s chain greased and tight
. You will need to tighten it after the first couple of rides. You can use the same chain grease that is used on a bicycle. To adjust
your chain simply loosen the shaft bolt that goes through the back tire. Then tighten the left and right chain tensioners with half turns equally. Allow some play in the chain. Do
not over tighten. Failure to properly maintain your chain will result in your chain coming off and could even damage your chain and sprockets.
Содержание EV Ultra Lite 1000
Страница 1: ...Electric Scooter Ev Ultra User Manual book...
