3-5
Err
= Will open the Error Logs Screen where you can see the number of error situations encountered.
See the next section for details on error codes.
ECS
=Will display the version of software in the ECS+ Control Box
SOF
= will display the version of firmware in the Handset
rES
= will place the system in Reset Mode, requiring the table to be fully lowered prior to resuming
normal operation.
SL
= This function has been removed.
SU
= This function has been removed.
CAL
= Allows the user to enter the actual height of the table top. The system will default to a generic
number if this is not set. Use up and down arrow buttons to adjust displayed height to match
measured height.
Un
= Units function allows the user to select metric or imperial units by pressing the up or down
arrow buttons. (Settings Menu.)
Exit
To enter a menu press up and down simultaneously.
To adjust a value once inside a menu press up or down.
To save and exit a menu press up and down simultaneously
Error Log Details
The Err option will display the Error Logs Screen where you are able to see the number of error
situations encountered. Use the up and down buttons to scroll through the codes.
LOH
= Log Over Heat - a motor has been overheated this number of times.
COH
= Card Over Heat - the ECS+ box has been overheated this number of times.
Tot
= Total adjusted distance.
The error counter is stored in the ECS+ box, not the handset so it is not important that the original
handset is used to review errors.
Error Codes
1. Hard Stop
2. Back off
3. Soft stop
