B. Standard hook-up to three terminal operators: For
direct connection loosen the three screws on the
operator and slide the brass terminals under these
screws. See Fig. 4. Replace the pushbutton
wiring and tighten the screws. Be certain the
antenna wire is hanging down vertically and the
receiver terminal numbers printed on the receiver
case match the numbers on the operator terminal
strip.
IMPORTANT: THE EXACT SAME CODE MUST BE SET ON
BOTH THE TRANSMITTER AND RECEIVER. IF JUST ONE
SWITCH IS MISMATCHED THE CONTROLS WILL NOT
FUNCTION.
MODEL 9921 AND 8822: The coding switch in these models
consists of eight or nine small switches each of which can be placed in two different positions,
On or Off. See Fig. 3. Using a small screwdriver, set the coding switches in both the transmitter
and receiver identically. (Your private code).
DO NOT SET ALL SWITCHEs IN THE SAME POSITION.
EXAMPLE:
Models 9931, 8832, 8833: The coding switch in these models consist of eight or nine small
switches, each of which can be placed in any of three different positions. (+, 0, -). See Fig. 2. Using a
small screwdriver, set both the transmitter and receiver coding switches identically. (Your private code
setting).
DO NOT SET ALL THE SWITCHES IN THE SAME POSITION. EXAMPLE:
STEP 2: INSTALL YOUR RECEIVER
A. The receiver was designed to be installed in a
variety of ways depending on the type of operator
and the application. If standard hook-up is not
desirable or possible, accessories such as three
wire adapter sets and transformer adapter kits
must be used.
NOT ALL + or 0 or -
NOT ALL
ON
or
OFF
(1)
FIGURE 3
C. Models 9921 or 9931
RELAY
24 VOLTS
COMMON
RADIO
POWER
3 2 1
FIGURE 4
FIGURE 2
104386
3 2 1
STEP 3: INSTALL YOUR TRANSMITTER
A. The transmitter can be either hand held or
mounted on the sun visor with the enclosed visor
clip. If sun visor mounting is desired attach the
visor clip as shown. (See Fig. 5)
If removal of the visor clip is necessary, place finger in
loop at top of visor clip, and thumb on top edge of
transmitter. Push down with thumb and pull up with
index finger. Clip should release and pull out easily.
B. If the operating distance drastically decreases, remove the battery access door See Fig.
1A, and replace the battery with a NEDA 1604, nine volt battery.
C. Models 9921 and 9931: To activate your garage Door or Gate, simply depress your
transmitter button until the door or gate starts to move.
D. Models 8822, 8832 and 8833: To activate the desired Garage Door or Gate control,
push either button (1) one, (2) two or (3) three, depending on which you desire to open
or close. Channel one (1) is the left button. Channel (2) is the center button. Channel
three (3) is the right button.
MODELS
8822 & 8832
MODEL
8833
D. Model 8832 - Double Door Garage
(1)
(3)
(2)
3 2 1
3 2 1
3 2 1
3 2 1
3 2 1
3 2 1
3 2 1
E. Model 8833 - Three Door Garage
(2)
(1)
FIGURE 5
104388
