Quick Start
Remove preamplifier from the box.
Attach the power cable to the IEC connector and plug into an
outlet. Turn the power switch next to the IEC connector on. This will
not turn the preamplifier on (unless you have Power-on Override
turned on, which you can do in the menu).
Hook up your sources as well as your power amp.
Once your system is set up and everything is hooked up, turn on
your preamplifier via the power button on the front panel. The
buttons are capacitive, so you only need to touch them, they do
not push in.
There is a turn-on delay of several seconds to allow the unit to
warm up.
Operation
The unit is designed to be powered on indefinitely without harm.
The front panel power button powers down the amplifier but the
power supply remains on in a nearly idle state. To turn the amp
completely off, use the power switch next to the IEC connector.
While it does not generate much heat, the unit is air cooled and
should be placed somewhere with adequate ventilation.
