LT6551
2
QUICK START PROCEDURE
Demonstration circuit 866 is easy to set up to evaluate
the performance of the LT6551. R efer to Figure 1 for
proper measurement equipment setup and follow the
procedure below :
1.
Prior to connecting the pow er supply, preset the out-
put voltage to 5V, or to the desired level, if different.
2.
W ith pow er off, connect the pow er supplies to V+ and
G N D using banana to clip-lead cables.
3.
If using a N etw ork Analyzer, perform the TH R U trans-
mission cal w ith all cabling, adapters, impedance con-
verters, etc. in place as the reference 0dB path.
4.
Energize the pow er supply.
5.
Connect the N etw ork Analyzer (if used) to the appro-
priate channels to measure frequency response and
crosstalk as desired.
6.
For video-signal evaluation, connect a component-
video signal source to the inputs and a monitor and/or
video analyzer to the outputs.
COM +
Power Supply
+5.00
+5.00
+5.00
+5.00
Inputs
Outputs
Figure 1.
Proper M easurem ent Equipm ent Setup
