ADJUSTMENT:
As shipped from the factory, the
PA-II
©
is set for the lowest sensitivity. This will
allow it to match the speaker level output of a standard deck. In order for the
input of the
PA-II
©
to match up to a lower level signal, the input level controls
must be set. These are accessible through holes on the rear panel, and can be
turned with a small flat blade screwdriver. There is a separate control for the left
and right channels.
Set the volume control on the source to maximum clean output.
Set the Gain control on the front on the
PA-II
©
to minimum.
Set all equalizer controls on the center position.
Rotate the input gain controls clockwise until the clip light just starts to flash.
The
PA-II
©
is now matched to the output of your source.
CONNECTOR LAYOUT
With the rear of the
PA-II
©
facing you, and the unit right side up, the connections
are as follows:
INPUT, (Left and Right); REAR output, (Left and Right); FADER INPUT, (Left
and Right); FRONT output, (Left and Right); OUTPUT, (Left and Right).
GENERAL TROUBLESHOOTING
NO SOUND
Check all connections. Check fuses. With a meter to be sure there is +12 volts on
the main power wire, but not on the ground wire. Check all signal connections to
insure that they are properly configured and that there are no shorts to ground.
Check by substitution or other method for proper operation of music source.
Check that the
PA-II
©
has been turned on.
BLOWS FUSE
Check all connections to be sure all power wires do not touch ground or each
other. Re-check polarity of main power wires.
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
LINEAR POWER™ is a trademark of Linear Power, Inc.
4
