Linea DOMO DO921WK, Инструкция пользователя

Страница: 20 / 44

20
DO921WK
EN
INSTALLATION
1. Remove all packaging materials and any promotional stickers.
2. Before connecting the appliance to the power net, leave it standing upright for about 2 hours. This
reduces the risk of any malfunctioning of the cooling system due to transportation.
3. Clean the inside of the wine cooler with lukewarm water and a soft cloth.
4. Place the appliance on a firm, steady surface, that is strong enough to carry a filled wine cooler. To
level the appliance, you can adjust the front support feet at the bottom of the appliance.
5. Do not place the appliance directly into sunlight or near heat sources. Direct sunlight could affect
the coating of the appliance and the proximity of heat sources may cause an increase of the energy
consumption. Extreme temperatures may also cause malfunctioning of the appliance.
6. Make sure that the air can circulate around the appliance. Therefore, leave a free space of at least 5
cm between the appliance and any other object.
7. The cord should not be exposed or left hanging loose to prevent possible accidents.
Make sure that the room temperature lies between 10°C and 26°C. If the temperature is higher or
lower, the performances of the appliance may be affected. The
temperature may vary depending on whether the bottles are on the
upper, middle or lower racks and whether the inside lighting is on
or not.
HANDLE
Attach the handle to the door with the supplied screws.
1.
Seal
2. Screws
3. Door
4. Handle
USE
CONTROL PANEL
Up Temperature Down Light
14
1 2 3 4
1. Display
2. Button to raise the temperature
3. Button to lower the temperature
4. On/off button of the light
· The desired temperature can be set using the buttons to raise or lower the temperature. (2+3) Pressing
these buttons, the temperature will change with 1°C each time you push the button.
· The temperature can be set between 10-18°C.
· You can read the selected temperature on the display.
· You can turn on/ off the lights inside the appliance by pushing the on/off button for the light. (4)
1
2
3
4