IPower 2x6
User Guide
Configuration - Power Ports
Label:
A name with a maximum of 15 characters
can be entered here for each Power Port.
After power-up switch:
The Power Port’s
switching state after a power-on can be defined as
on, off, or remember last state.
If switching on after power-up, wait
...: A
switching delay of a Power Port can be defined
with a wait of up to 8191 seconds.
Combine A-B Ports:
The Power Ports of Source
Bank A and its equivalent of Bank B (Example A2 -
B2) can be switch synchronized. Power Ports that
are configured for combined switching are marked
with a C in the Switching menu and the serial
interface.
Configuration - IP Address
Hostname:
Enter the host name of IPower 2x6.
IPower 2x6 uses this name to connect with the
DHCP server. Using special signs may destabilize
your network. In this example we named the
Switch EPC-NET-2x6.
IP Address:
You can manually enter an IP
address in this field.
Netmask:
You can manually enter a Netmask in
this field.
Gateway:
You can change the standard gateway
address.
Use DHCP:
You can select if the switch should get its TCP/IP settings directly from your DHCP server. If
there is no DHCP server on your network, we recommend deactivating this function.
Configuration IP ACL
Reply ICMP-Ping requests:
You can set if the Switch should
reply to pings.
Enable IP Filter:
You can activate the IP Access Control List
(IP ACL) of the Switch. If IP ACL is active, DHCP and SNMP
will only work, if all necessary servers and clients are
registered in this list.
Содержание IPower Control 2x6
Страница 2: ......
