- 7 -
8. Remove the Driver diskette and click
Yes
to restart Windows to complete driver
installation.
For Existing Windows ME Systems
1. After the
SATA RAID PCI Host Adapter and attached drives are configured, boot up
Windows.
2. At the
Add New Hardware Wizard
, check
Specify the location of the driver
(advanced),
and click
Next
.
3. Insert the Driver diskette, check
Specify a location,
uncheck the other boxes, type
in
A:\,
and click
Next
.
4. Click
Next
and then
Finish
.
Verification of the Proper Installation for Windows 98/98SE/ME
1. Double click
My Computer/Control Panel/System
. Click
Device Manager
tab.
2. Double click
SCSI Controllers
,
Silicon Image Sil-3112 SATA Raid Controller
should be listed.
3. Highlight
Silicon Image Sil-3112 SATA Raid Controller
and click
Properties
.
A message
This device is working properly
is displayed in the dialog box, the driver
has been correctly installed. If any error message is displayed, remove
Silicon Image
Sil-3112 SATA Raid Controller
and restart your system.
4.3. Windows NT 4.0 Driver Installation
For New Windows NT 4.0 System
1. After the SATA RAID PCI Host Adapter and attached drives are configured, follow
Microsoft procedures to install Windows accordingly.
2. At the
Windows Set-up
screen, press
F6
to specify and add the driver.
3. Press
S
, select
Other
, then press
Enter
.
4. Insert the Driver diskette and press
Enter
.
5. Select
Silicon Image Sil-3112 SATA Raid Controller Driver
and press
Enter
.
6. Press
Enter
to continue and follow on-screen instructions to complete Windows NT
4.0 installation.
Add Windows NT 4.0 Driver on Original Booting Device
1. After the
SATA RAID PCI Host Adapter and attached drives are configured, boot up
Windows. Double click
My Computer/Control Panel/SCSI Adapters
, then click the
Drivers
tab.
2. Click
Add…
then
Have Disk...
.
3. Insert the Driver diskette into the floppy drive and type in
A:\
, then click
OK
.
4. Highlight
Silicon Image Sil-3112 SATA Raid Controller
and click
OK
.
