Troubleshooting
The display shows a black screen
•
Ensure that both ends of the Fibre Optic Cable are firmly
connected
•
Check the source is powered on and in the case of a PC,
booted up
•
Reset the system by un-plugging and re-plugging the
Transmitter and Receiver modules
The image is distorted or displays noise
•
Check the graphics resolution is set correctly
•
Ensure the resolution set is no higher than (WUXGA)
1920x1200 at 60Hz refresh rate
•
Reset the system by un-plugging and re-plugging the
Transmitter and Receiver modules
Maintenance
No special maintenance is required for the LINDY Fibre Optic DVI-D
Cable. Ensure the cables are stored or used in a benign environment
free from liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues
to LINDY.
Product Specifications
•
Complies with DVI standards: supports DVI 1.0 and DDC2B
mode, fully implemented by fibre optic communication
•
Extension limit: 100m (330 Feet) for WUXGA 1920x1200 at
60Hz refresh rate
•
Graphic Transmission Bandwidth: support WUXGA at 60Hz, or
1.65 Gbps bandwidth per graphic channel
•
Hybrid Fibre Optic Cable: Riser jacket of retardant PVC
employing 4 strands
•
Tensile Load: 1,800N
•
Minimum bend radius: 15.4cm
•
Cable outer diameter: 7.6mm
•
Mechanical Specifications of modules
•
Dimensions: 39 x 53 x 15mm (WxDxH)
•
Clamping strength to cable: 14kg
•
Environmental Specifications
•
Operating temperature: 0° to 50°
•
Storage temperature: -10° to 70°
•
Humidity: 10% to 85%
Warranty Information
LINDY Electronics warrants this Fibre Optic DVI-D Cable to be free from
defects in workmanship and materials, under normal use and service, for
a period of 2 years from the date of purchase.
Limitation and Exclusion
LINDY Electronics shall have no further obligation under the foregoing
limited warranty if the product has been damaged due to abuse, misuse,
neglect, accident, unusual physical or electrical stress, unauthorised
modifications, tampering, alterations, or service other than by LINDY,
causes other than from ordinary use or failure to properly use the
product in the application for which it is intended.
Technical Support and Service
For technical help & general product support contact LINDY by email:
or visit our website at
www.lindy.co.uk
Certifications
WEEE (Waste of Electrical and Electronic
Equipment),
Recycling of Electronic Products
United Kingdom
In 2006 the European Union introduced regulations (WEEE) for the
collection and recycling of all waste electrical and electronic equipment.
It is no longer allowable to simply throw away electrical and electronic
equipment. Instead, these products must enter the recycling process.
Each individual EU member state has implemented the WEEE
regulations into national law in slightly different ways. Please follow your
national law when you want to dispose of any electrical or electronic
products. More details can be obtained from your national WEEE
recycling agency.
FCC Certifications
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the
interference at their own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received;
including interference that may cause undesired operation.
CE Certification
This
equipment complies
with
the
requirements
relating
to
electromagnetic compatibility, EN 55024 and EN55022 class A for ITE,
EN61000-3 the essential protection requirement of Council Directive
89/336/EEC on the approximation of the laws of the Member States
relating to electromagnetic compatibility.
LINDY No’s 41300 to 41306
www.lindy.com
3rd Edition November 2010
