LINDR AS-160 INOX TROPICAL, Инструкция по эксплуатации

Страница: 14 / 24

14
14. TAP INSTALLATION:
figure
14 C
figure
14 D
1.
Turn the compensator lever (1.), so that it points down (see figure).
The compensator lever on the tap is used to adjust the flow rate.
2.
Fit the tap perpendicularly onto the spline.
3.
Secure with a flare nut and turn left. (loosen to the right).
4.
Tighten with the enclosed wrench.
figure
14 E
figure
14 F
min.
max.
1.
13. HOW TO WORK WITH SPEED FITTINGS:
13.1 Speed Fitting Installation:
Grasp the speed fitting and insert the hose all
the way inside the speed fitting body (ca. 20
mm). The end of the hose must be straight so
that it plugs fully into the coupling. If the hose
will not go in, moisten the end of the hose.
figure
14 A
13.2 Speed Fitting Removal:
Hold the grey ring tight against the body of
the speed fitting and pull out the hose.
figure
14 B
WARNING: If you do not hold the grey ring but pull at the hose, the speed fitting will cut
even deeper into the hose.
WARNING:
Hoses must not be pressurised during removal.