12/21
Linde AG, Linde Gas Deutschland ©
Flux core
0,8-1,0
2318
1,0-1,2
2319
6. GETTING STARTED MIG/MAG
Getting started must be consistent with technical data and conditions of use.
CHOOSING THE FEEDING ROLL
In all machines (Linde AG, Linde Gas Deutschland MIG / MAG) rolls with two
grooves are used. These grooves are intended for two different wire diameters
(e.g. 0,8 and 1,0 mm).
Rolls for wire feed must comply with the diameter and material of the welding
wire. Only this way a smooth wire feed can be achieved. Irregularities of the
wire feed leads to a poor quality of welding and deformation of the wire.
∅ 1,0
1,0
1,2
0,8
A
B
C
Fig. 5
The influence of the roll groove on the welding wire
INSERTING THE WIRE
1. Open the side cover of the wire feeder space
2. Put the wire spool on the wire spool holder
D1
and fix it with the fixing nut
D2
.
3. Cut off the curved or damaged end of welding wire and lead it through
the inlet liner
E3,
and the roll into the liner inside the EURO torch
connector (about 5 cm). Make sure, that you use the suitable groove.
4. Put the pressure arm
E2
down in that way, that the teeth or the gear fit
and fix it by setting the lever
E1
into vertical position.
5. Adjust the pressure nut that way that it provides constant movement of
wire but it does not deform wire. The adjusting screw is located under the
plastic screw
E1
.
6. The spool brake is set by the manufacturer. If necessary, the brake can
be adjusted by a screw
D1
so that while stopping the feed, spool will be
stopped on time (it will avoid excessive release of wire).However, too
A Correct
B Wrong
C Wrong