Lindam LD167, Руководство пользователя

Страница: 4 / 64

4
SETTING UP THE BABY UNIT
MAINS POWER
1. Plug your adaptor in to your mains socket and connect to your camera.
2. Slide the On / Off Switch to the On position. The Power Indicator will illuminate red.
WARNING! Only use the Adaptors labelled OUTPUT: 6V DC that were supplied with your monitor. The use of other power
supplies is not approved and may damage your product and will invalidate your warranty.
BATTERY POWER
The camera uses either 4 AAA batteries (alkaline battery recommended) or your Mains Adaptor.
1. Remove the small screw using a flat head screwdriver and remove the Battery Compartment Cover
2. Insert 4 AAA batteries ensuring correct polarity
3. Replace the battery compartment cover and replace the screw and gently tighten.
4. Slide the On / Off Switch to the On position. The Power Indicator will illuminate red. The Power Indicator will start blinking
when the power is low. When this occurs replace your batteries.
NOTE! Do not mix old and new batteries. Remove the batteries if you are not planning on using the monitor for long periods
to avoid corrosion in the event of a leakage. Remove the batteries when using the mains adapter.
NOTE! Check the low battery warning light regularly. We strongly recommend using only recognised brand batteries to ensure
a long battery life.