OPERATING MANUAL
STEP 1: ASSEMBLY
Assembling the StaticSure is fast and easy.
+
Plug each of the two (2) cables into opposite ends of the StaticSure device
and tighten them securely.
+
Either cable can be plugged into both sides of the device - there is no right or
wrong side.
+
Ensure that the ridge (FIGURE 1) on the device connector aligns with the groove
in the cable connector prior to pushing and tightening.
HOW TO USE THE StaticSure
STEP 2: SET UP
a) Bonding Applications:
Bonding refers to creating a link between two objects using
a conductive material (e.g. a wire) in order to ensure that they remain at the same
electrical potential, thus reducing risk of static discharge between the objects.
+
The device can be attached to the objects that you wish to bond using either a
lug terminal which can be bolted to an object, or a hand clamp.
+
Once the cables have been assembled per STEP 1, you should attach one side
of the StaticSure assembly to one of the objects you wish to bond using either a
clamp or a lug termination.
+
You must ensure that metal to metal contact is made by either the jaws of the
clamp or the lug terminal in order to establish proper continuity.
+
If the red light is flashing after attaching this side, you do not have good metal to
metal contact and should reattach this side until the light goes off.
+
The other side of the assembly is now ready to be attached to the second object
that you wish to bond (FIGURE 2),
but first the device should be tested
.
+
See STEP 3 for testing instructions.
HOW TO USE THE StaticSure
4
LIND EQUIPMENT LTD. T: 877.475.LIND www.lindequipment.net
LIND EQUIPMENT LTD. T: 877.475.LIND www.lindequipment.net
5
FIGURE 1
FIGURE 2
Align groove on connector
with pin on receptacle
