English 29 English
Turning the Allen screw M8 anticlockwise decreases the
spring tension and you can decrease the brake torque.
After finishing of adjustment, you should screw in the
fastening cap again.
Adjusting of Pressure Roll Force
The pressure arm controls the amount of force the drive
rolls exert on the wire.
Pressure force is adjusted by turning the adjustment nut
clockwise to increase force, counterclockwise to
decrease force. Proper adjustment of pressure arm
gives the best welding performance.
WARNING
If the roll pressure is too low the roll will slide on the wire.
If the roll pressure is set too high the wire may be
deformed, which will cause feeding problems in the
welding gun. The pressure force should be set properly.
Decrease the pressure force slowly until the wire just
begins to slide on the drive roll and then increase the
force slightly by turning of the adjustment nut by one
turn.
Inserting Electrode Wire into Welding
Torch
Turn the welding machine off.
Depending on welding process, connect the proper
gun to the euro socket, the rated parameters of the
gun and of the welding machine should be matched.
Remote the nozzle from the gun and contact tip or
protection cap and contact tip. Next, straighten the
gun out flat.
Turn the welding machine on.
Hold the Cold Inch/Gas Purge Switch in the Cold
Inch position.
When the switch is released spool of wire should
not unwind.
Adjust wire spool brake accordingly.
Turn the welding machine off.
Install a proper contact tip.
Depending on the welding process and the type of
the gun, install the nozzle (GMAW process) or
protection cap (FCAW process).
WARNING
Take precaution to keep eyes and hands away from the
end of the gun while the wire is being come out of the
threated end.
Changing Driving Rolls
WARNING
Turn the input power off before installation or changing
drive rolls.
POWERTEC i250C STANDARD/ ADVANCED,
POWERTEC i320C STANDARD/ ADVANCED
is
equipped with drive roll V1.0/V1.2 for steel wire.
For others wire sizes, is available the proper drive rolls
kit (see "Accessories" chapter) and follow instructions:
Turn the input power OFF.
Unlock 4 rolls by turning 4 Quick-Change Carrier
Gear [52].
Release the pressure roll levers [53].
Change the drive rolls [51] with the compatible ones
corresponding to the used wire.
WARNING
Be sure that the gun liner and contact tip are also sized
to match the selected wire size.
WARNING
For wires with the diameter larger than 1.6mm, the
following parts are to be changed:
The guide tube of the feeding console [49] and [50].
The guide tube of the Euro Socket [48].
Lock 4 new rolls by turning 4 Quick-Change Carrier
Gear [52].
Manually feed the wire from the wire reel, the wire
through the guide tubes, over the roller and through
the guide tube of Euro Socket into liner of gun.
Lock the pressure roll levers [53].
Figure 70.
Gas Connection
A gas cylinder must be installed with a proper flow
regulator. Once a gas cylinder with a flow regulator has
been securely installed, connect the gas hose from the
regulator to the machine gas inlet connector.
WARNING
The welding machine supports all suitable shielding
gases including carbon dioxide, argon and helium at a
maximum pressure of 5,0 bars.
WARNING
Always fasten gas cylinder properly in vertical position in
a special holder on the wall or on a carriage. Remember
to close gas cylinder valve after having finished welding.
WARNING
Gas cylinder can be fasten on the machine’s shelf, but
the height of gas cylinder doesn’t have to be higher than
43in/1,1m. The gas cylinder which is fastened on the
machine’s shelf has to be secured by attaching it to the
machine using the chain.
