Deactivating/activating the BeltMinder
姞
feature (if equipped)
Read Steps 1 - 4 thoroughly before proceeding with the
deactivation/activation programming procedure.
The driver BeltMinder
威
feature can be deactivated/activated by
performing the following procedure:
Before following the procedure, make sure that:
•
The parking brake is set
•
The gearshift is in P (Park) (automatic transmission)
•
The ignition switch is in the OFF position
•
The driver safety belt is unbuckled
To reduce the risk of injury, do not deactivate/activate the
BeltMinder
威
feature while driving the vehicle.
1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately
1 minute)
•
Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. At a moderate speed, buckle then unbuckle the safety belt 9 times,
ending in the unbuckled state. (Step 3 must be completed within
50 seconds after the safety belt warning light turns off.)
•
After Step 3, the safety belt warning light will be turned on for three
seconds.
4. Within 10 seconds of the light turning on, at a moderate speed, buckle
then unbuckle the safety belt.
•
This will disable the BeltMinder
威
feature for that seating position if it
is currently enabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds.
•
This will enable the BeltMinder
威
feature for that seating position if it
is currently disabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds, followed by 3 seconds with the
light off, then followed by the safety belt warning light flashing 4 times
per second for 3 seconds again.
2007 Navigator
(nav)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
132