*if equipped
*if equipped
13
2 0 1 9 N a u t i l u s
12
Power Liftgate*
Your liftgate has an automatic open and close feature.
To open remotely, press
twice on your remote control within three seconds.
You can also operate the liftgate by pressing the
button on the instrument
panel. To close the liftgate, press and release the liftgate control button on
the liftgate
.
To Set the Liftgate Open Height
1. Open the liftgate.
2. Stop the liftgate movement by pressing the control button on the liftgate when
it reaches the desired height.
3. Press and hold the control button on the liftgate until you hear a tone,
indicating programming is complete.
The system recalls the new open liftgate height when you use the power liftgate
feature. To change the programmed height, repeat the procedure.
Note:
You cannot program the height if the liftgate position is too low. Once you
open the power liftgate, you can manually move it to a different height. When
operating the power liftgate after you have programmed a lower height than
full-open, you can fully open the liftgate by manually pushing it upward to the
maximum open position.
Hands-free Liftgate Operation
*
1. Make sure you have your intelligent access transmitter within
3 feet (1 meter) of the liftgate.
2. Move your foot under and back from the rear bumper (between the exhaust
tips), similar to a kicking (front-to-back) motion. Do not move your foot
sideways or the sensors may not detect the motion.
Note:
In vehicles equipped with the towing package, you must kick your
foot
between
the trailer hitch and the exhaust system. Do not kick under
the trailer hitch.
Wireless Accessory Charging*
This feature supports QI inductive charging-
compatible devices. You can only charge one
device on the charging area. You can charge a
device if the vehicle is off, in accessory mode or
if SYNC is on. Keep the charging area clean and
remove foreign objects prior to charging a device.
To begin charging your device, place the device in the port with the charging side
down. The charging stops after your device reaches a full charge.
For more information, see the
Auxiliary Power Points
chapter of your
Owner’s Manual.
Front Fog Lamps*
Press to switch the fog lamps on or off.
You can switch the fog lamps on when the lighting control is in any position
except off and the high beams are not on.
Comfort
Climate Controlled Front Seats
For heated front seats, press
repeatedly to cycle through the
various heat modes and off. For cooled
front seats, press
repeatedly to
cycle through the various cooling
modes and off.
Note:
The ventilated seats function
only when the engine is running.
Rear Heated Seats
*
The rear heated seat controls are on
the rear of the center console. Press
to switch between the high, low
and off settings.
EasyFold® Rear Folding Seats
The controls are on the left-hand rear
quarter trim panel (accessible from the
liftgate area). Press and hold either
the left or right control to lower the
corresponding seatback. To return the
seats to their upright position, manually
rotate the seatbacks until they latch
with a click into the upright position.
Reclining Rear Seats
*
With the seat occupied, pull the
lever up to recline the seatback.
Heated Steering Wheel
*
Your vehicle may include a heated
steering wheel. Press the
icon in
your touchscreen to turn this feature
on and off.
Power Adjustable Seats*
You can adjust your driver seat in a
variety of ways:
Press
A
to raise, lower and tilt the
head restraint.
Press
B
to use the multi-contour
front seats with active
motion functions.
Press
C
to change the backrest
angle and move the upper back
restraint pivot point forward
and rearward.
Press
D
to raise, lower, move
forward or backward or tilt
the cushion.
Press
E
to adjust the cushion length.
The front seats also include a
massaging feature. See the
Seats
chapter of your
Owner’s Manual
for
more details.
Locking Glove Box*
You can open the glove box by
pressing the button located on the
instrument panel.
Note:
The electronic glove box does
not function if the vehicle battery is
dead or after you switch the ignition off
and lock the vehicle.
Manual Entry
1. Open the passenger door.
2. Remove the end cap from the
instrument panel.
3. Insert a pen or pencil into the latch
device to release the glove box.
*if equipped
Convenience
