Part Number 11020000499 Rev B (1/17)
17
Section 2
Installation
FIGER ASSEMBLIES
1. Verify that the top
retaining bracket with
the “T” mark is on the
top, and the “B” mark is
on the bottom retaining
bracket.
2. Before installing the
retaining brackets in
the oven(s), be sure all
of the packing material
is removed from the
plenum shroud. Install
the finger retaining
brackets by placing
them upside down and
hooking the retaining
pin as shown. (
See
Figure 1
.)
3. Rotate the finger
brackets until the
notches in the brackets
sit on the retaining pins.
(
See Figure 2.
)
4. Assemble fingers as
shown in
Figures 3
and 4
.
5. Insert columnating
plate so the step goes
under the lip of the
finger housing and the
plate lies flush with the
housing side edge.
6. Install cover by sliding it
on the small end. (
See
Figure 5.
)
Figure 4
Figure 5
7. Insert assembled finger through door opening, starting
with lower left. NOTE: The customer MUST tell you
which position to place the assembled finger in for
their application.
8. Install the finger in the oven by sliding it over the
plenum flange and setting the front bracket.
(See
Figures 6 and 7
.) BE SURE THAT THE FINGER SITS
SQUARELY OVER THE PLENUM FLANGES AND THE
HOLES POINT IN THE PROPER DIRECTION. Top fingers
point down, bottom fingers point up. (
See Figure 8
.)
9. Repeat step 8 until all eight (8) fingers are installed.
10. Install conveyor and crumb pans before operation. See
“Weekly Cleaning” in Section 4 for instructions.
11. Attach Motor Cover as shown with bolts provided.
12. You are now ready for services to be connected. This
should be done by licensed electricians and plumbers.
See the specifications sections and “Installation
Requirements” for more information.
3240 Gas
Figure 7
Figure 6
Figure 8
3240 60 Hz Electric
3240 50 Hz Electirc
Figure 1
Figure 2
Figure 3
