A - 4
CALIBRATION
MAGNUM
®
PRO AL Gun
CALIBRATION
FOR LINCOLN 25M
In order to time the Lincoln Magnum Pro AL Gun so that
it runs a fraction slower than the wire feeder, perform the
following:
1. Turn off all settings by pressing the right soft key and using
the dial to adjust (see below). Please record these setting as
they will be needed at the end of this procedure: preflow, run-
in, start time, spot timer, crater time, burn back, post flow.
2. Adjust the wire speed to 360 inches per minute by either
turning the pot on the torch or adjusting the dial below the
display (see below). 360 inches in one minute is the same as
60 inches in 10 seconds. This number will be critical later.
3. Turn off the water re-circulator (if applicable) and disconnect
the ground. Disengage the drive motor (Figure 1), disconnect
the torch from the cabinet, and clip the wire (Figure 2).
The gun is to run with the wire cut-off at the front panel of the
feeder and pull wire through conduit only (Figure 3).
Figure 1
4. Using a stopwatch, press the trigger for ten seconds.
Measure from the tip of the torch to the end of the wire
(Figure 4).
The number you are trying to achieve is just below 60 inches
(360 inches in 1 min is the same as 60 inches in 10 sec), if
you measured just below 60 inches (Figure 5) skip to step 8.
5. Press both soft keys simultaneously to get into the user
settings (Figure 6).
Scroll to setting P7 using the dial (Figure 7).
Press the adj soft key to adjust the setting (Figure 8).
6. The P7 setting works as follows: Range is from -30 to +30,
the lower the number the slower the motor goes, the higher
the number the fast the motor goes. If you measured 72
inches, turn the setting down, if you measured 48 inches,
turn the setting up (Figure 9).
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Содержание MAGNUM PRO AL G225A
