EN
8
LINCGUN
®
PROMIG
™
UD
Manual
Lincoln Electric Europe
EU DECLARATION OF CONFORMITY
Manufacturer and technical
documentation holder:
Lincoln Electric Iberia S.L.
Ctra. Laureà Miró 396-398
08980 Sant Feliu de Llobregat (Barcelona)
Spain
This declaration of conformity is issued under the sole responsibility of the manufacturer.
Object of the declaration:
Welding Equipment
Product numbers:
LINCGUN PROMIG 300 UD 4M
LINCGUN PROMIG 500W UD 4M
The object of the declaration described above is in conformity with the relevant Union harmonisation
legislation:
Is in conformity with Council Directives
and amendments:
Low Voltage Directive 2014/35/EU
RoHS Directive 2011/65/EU
References to the relevant harmonized standards used, and references to the other technical
specifications in relation to which conformity is declared:
EN 60974-7: 2013 ; Arc Welding Equipment
- Part 7: Torches
Signed for and on Behalf of:
Lincoln Electric Iberia
Agnieszka Kujacz - Koralewska
Product Manager Equipment Welding Guns EMEAR
Barcelona, 27.03.2022
MAINTENANCE
Periodically remove and clean the nozzle, contact tip and gas diffuser.
Replace the nozzle if damaged. Regular use of an antispatter compound
will reduce the adherence of spatter and ease its removal. Clean cable
liner after using approximately 140 kg of electrode. Remove the cable
from the wire feeder and lay it out straight on the floor. Remove the
contact tip from the gun. Using an air hose and only partial pressure,
gently blow out the cable liner from the gas diffuser end.
CAUTION!
Excessive pressure at the start may cause the dirt to form a plug.
Flex the cable over its entire length and again blow out the cable.
Repeat this procedure until no further dirt comes out.
W100000297, W100000298
LGP_UD_2022/04 rev1
