Lincoln Electric Infinity-Pak K3926-1, Руководство оператора

Страница: 11 / 24

B-2
OPERATION
INFINITY-PAK ® STATION
3.0 BUTT WELDING INSTRUCTIONS
1. Ensure the Wire Size Select switch is in the OFF position. (center).
Connect Butt Welder to power supply.
2. Pull down both locking knobs to open wire clamps.
3. Pull and turn the Weld/Open switch to the “Open” position.
4. Snip off each end of the wire using a pair of Wire Parters
(included). Insert each wire end in groove until centered in the
space between the 2 jaws. Lock wire into place one side at a time
by pulling the locking knobs back into place. Ensure the wire butts
are flat and evenly spaced.
5. Turn the Weld/Open switch to the “Weld” position.
6. Turn switch on base unit to appropriate setting for wire size.
7. Press and hold green Cycle Start button on the front panel to weld
the wire ends together (there will be a slight delay). If the Reset is
popped out, push back in to weld.
Keep hands clear of butt welder components and wire
when welding.
8. Open wire clamps by pulling down both locking knobs. Remove
wire.
Wire may be hot!
9. Remove the burr in the wire joint using the optional Wire Sizer (see
below) or other method of creating a smooth joint. Check the joint
using the Wire Gage Block to ensure smooth wire feeding.
10. Insert wire onto pathway between the two wire packages. Repeat
process when replacing empty boxes.
Burr Removal from Wire
Joint using the Wire Sizer
To remove the burr in the wire
joint, open clamps on the wire
sizer and position wire as shown
in step 1. The joint should be in
the gap on the left side (circled).
Close and tighten clamps. Pull the
handle firmly to the right to
remove the burr. Unlock the
clamps and remove wire.
CAUTION
CAUTION
Front Panel Front Panel
Butt Welder